This is the view inside the technical room.
The far end would still be my table, which
my Boss have to maintain as I am the Big
Shot in there. *ahem*
The far end would still be my table, which
my Boss have to maintain as I am the Big
Shot in there. *ahem*
Minutes later, the inner walls were put up. Note that
this is our own office and we're the one doing all these
renovations. So, we do learn a lot of stuff in the process.
this is our own office and we're the one doing all these
renovations. So, we do learn a lot of stuff in the process.
We also learnt that in the future, we would need this
"robot" (I prefer rocket) and should call the other
contractor well in advance to borrow it. So we
would not need an hour with strings and the
water hose pipes to get things done. But we do
learn a lot though. The rocket would have cut
our education short and get the things done in
minutes
"robot" (I prefer rocket) and should call the other
contractor well in advance to borrow it. So we
would not need an hour with strings and the
water hose pipes to get things done. But we do
learn a lot though. The rocket would have cut
our education short and get the things done in
minutes
Boss also taught me how to make holes,
especially the rectangular ones, with this
partition saw. Its sharp enough to stab
you and still be able to make a nice hole
in your abdomen/head/butt, etc.
especially the rectangular ones, with this
partition saw. Its sharp enough to stab
you and still be able to make a nice hole
in your abdomen/head/butt, etc.
After struggling with the saw for almost ah hour,
the holes are almost done. But I have to wait for
my Boss to get away from behind the wall in case I
stab him while doing the last rectangular hole....
the holes are almost done. But I have to wait for
my Boss to get away from behind the wall in case I
stab him while doing the last rectangular hole....
By almost eight in the evening, the walls are almost
done. Now, its just the matter of reinforcing the holes
I have cut with more metal frames before sealing it
with the plaster wall. Once the window and the door
are in, we can start filling the gaps with plaster
done. Now, its just the matter of reinforcing the holes
I have cut with more metal frames before sealing it
with the plaster wall. Once the window and the door
are in, we can start filling the gaps with plaster
Here is how the gap-filling plaster are being prepared:
You just add water and when the water have all been
absorbed, its ready to go into the walls. Due to my
expertise with non-electronics practical work, I am
not allowed to do any of this stuff in case I cause more
damage. But seriously, this is a job where if you cannot
do anything, you just try to help out or just stand away.
You just add water and when the water have all been
absorbed, its ready to go into the walls. Due to my
expertise with non-electronics practical work, I am
not allowed to do any of this stuff in case I cause more
damage. But seriously, this is a job where if you cannot
do anything, you just try to help out or just stand away.
No comments:
Post a Comment